IPv4 addresses used up
- Brightonian
- Dorkwood
- Posts: 1447
- Joined: Mon Nov 11, 2019 3:16 pm
- Location: Usually UK, often France and Ireland
Re: IPv4 addresses used up
Is the internet full, then?
And remember that if you botch the exit, the carnival of reaction may be coming to a town near you.
Fintan O'Toole
Fintan O'Toole
- Bird on a Fire
- Princess POW
- Posts: 10142
- Joined: Fri Oct 11, 2019 5:05 pm
- Location: Portugal
Re: IPv4 addresses used up
What does the slash mean in /22 and /8 and so on?
It's times like this I realise I have zero clue how the internet actually works.
We have the right to a clean, healthy, sustainable environment.
Re: IPv4 addresses used up
It's the size of subnet - roughly the size of the pool of addresses that a machine will try to talk to directly rather than going via a gateway if it's in your network subnet settings, or in this particular situation, an assignment of a subset of the total IPV4 address space to a subsidiary authority for them to assign.Bird on a Fire wrote: ↑Tue Nov 26, 2019 1:57 pmWhat does the slash mean in /22 and /8 and so on?
It's times like this I realise I have zero clue how the internet actually works.
For example, the group assigned 192.168.40.0/22 controls everything from 192.168.40.1 to 192.168.43.255, and can hand out those addresses to individual machines on their network for routing to from the wider internet.
(Except the 192.168.x.x space is an example here, and isn't routed on the internet. It's for use within private networks that aren't routed to directly from the internet. Most home networks, for example, operate in this space, with the access point/router assigning addresses in the 192.168.x.x space, and translating those addresses onto the ISP network. Which is probably also do the same thing one level up)
Last edited by dyqik on Tue Nov 26, 2019 2:07 pm, edited 2 times in total.
- Bird on a Fire
- Princess POW
- Posts: 10142
- Joined: Fri Oct 11, 2019 5:05 pm
- Location: Portugal
Re: IPv4 addresses used up
Ok thanks. I figured that it was presumably some kind of multiplier that would result in a pretty big number, but nice to know how it works.
We have the right to a clean, healthy, sustainable environment.
- Little waster
- After Pie
- Posts: 2385
- Joined: Tue Nov 12, 2019 12:35 am
- Location: About 1 inch behind my eyes
Re: IPv4 addresses used up
No we just have to squeeze the kittehs closer together.
This place is not a place of honor, no highly esteemed deed is commemorated here, nothing valued is here.
What is here was dangerous and repulsive to us.
This place is best shunned and left uninhabited.
What is here was dangerous and repulsive to us.
This place is best shunned and left uninhabited.
Re: IPv4 addresses used up
Or use bonsai kittens.Little waster wrote: ↑Tue Nov 26, 2019 3:17 pmNo we just have to squeeze the kittehs closer together.
Re: IPv4 addresses used up
I have been wondering about this since we were sternly told that ipv6 was where we were going several years ago. I suppose my ISP has its batch of v4 addresses and will carry on using them. I think my router will need a firmware upgrade before it can speak them.
Re: IPv4 addresses used up
The RIPE annoucement above mentions carrier grade NAT, which is one way of dealing with things. For devices that don't need fixed IP addresses (pretty much anything that you could happily use on a home WiFi network), then you can do NAT all the way up to the ISP gateway level .greyspoke wrote: ↑Tue Nov 26, 2019 4:44 pmI have been wondering about this since we were sternly told that ipv6 was where we were going several years ago. I suppose my ISP has its batch of v4 addresses and will carry on using them. I think my router will need a firmware upgrade before it can speak them.
Re: IPv4 addresses used up
So my ISP can keep using v4 in its customer facing part, but use v6 in its internet facing part? And NAT v6 addresses so they appeared to be v4 to me? It would still be limited to its block of v4 addresses though?
Re: IPv4 addresses used up
I'm better informed but none the wiser.
As BOAF has zero clue, I must have a negative clue how the internet works
As BOAF has zero clue, I must have a negative clue how the internet works
Have you considered stupidity as an explanation
- Pucksoppet
- Snowbonk
- Posts: 599
- Joined: Mon Nov 11, 2019 8:13 pm
- Location: Girdling the Earth
Re: IPv4 addresses used up
Carrier Grade NAT (or at least the version my ISP used) does not play nicely with dynamic DNS services. The 'solutions' I have seen start with "First get a VPS with a public IP address..." and describe how to set up a persistent tunnel to the VPS from the device behind CGN and send all inbound and outbound traffic through that tunnel.dyqik wrote: ↑Tue Nov 26, 2019 4:46 pmThe RIPE annoucement above mentions carrier grade NAT, which is one way of dealing with things. For devices that don't need fixed IP addresses (pretty much anything that you could happily use on a home WiFi network), then you can do NAT all the way up to the ISP gateway level .greyspoke wrote: ↑Tue Nov 26, 2019 4:44 pmI have been wondering about this since we were sternly told that ipv6 was where we were going several years ago. I suppose my ISP has its batch of v4 addresses and will carry on using them. I think my router will need a firmware upgrade before it can speak them.
For people who don't wish to run home servers accessible from the Internet at large, CGN is reasonable, but the answer is to use IPv6, which is why having ISPs drag their feet over IPv6 deployment is irritating.
Re: IPv4 addresses used up
My home server does do ftp, which saved me a sweaty 30 min round trip by bike when I had forgotten to upload stuff to work for the lecture I was about to deliver. I suppose I don't need it now, but last time I looked it was still working. And I have done some research, my ISP (PlusNet) doesn't do v6. As it is a subsidiary of BT, I assume this is deliberate in some way (PlusNet being marketed as a cheaper less good service?) I guess it isn't needed for most of their customers until a site people want to visit only has a v6 address.
Re: IPv4 addresses used up
From my service provider yesteryear summer: https://blog.one.com/one-com-is-ipv6-ready/
Read details:
Read details:
One.com has just completed its migration of all subscriptions to the IPv6 standard.
But what is an IP anyways?
You might have heard of IP (Internet Protocol) before: Whenever you go online, your internet service provider provides you with an IP address, for example, 192.168.1.1. This allows other devices to identify and connect to you. Now, if you open One.com, you connect to the IP 46.30.211.35. It will then send the homepage to your IP address.
As you can see, each IP address consists of four blocks of numbers — this defines the IPv4 standard, which is still the most used standard. You can imagine that with more and more people, servers and smart toasters going online, those IP’s might sooner or later run out. In fact, they already have: back in 2011, all 4.3 billion combinations were distributed for good! Without an alternative, new websites, companies or even entire emerging markets wouldn’t have any chance to engage in the online world.
This is where IPv6 comes to the rescue because it allows for much more complex IP addresses (e.g., 200185a3:0000:0000:8a2e7334), increasing the number of available IP’s dramatically. IPv6 was already established back in 1998; however, it took many years for websites, let alone internet service providers to implement it robustly. Twenty years later, we are finally ready to roll out IPv6 to your websites.
The numbers speak for themselves
One out of five sites now uses IPv6 according to Google, though adoption levels vary by country. Only a handful of nations deliver more than 5% of traffic over IPv6. Belgium provides an encouraging outlook; it is the first country in the world to deliver more than half of its traffic to content providers over IPv6 according to InternetSociety report 2018.
But what does this mean for me?
First of all, your DNS settings in your Control Panel have gotten just a bit more granular. For instance, you can now turn on and off access to your domain via IPv6 by toggling the respective “standard web DNS settings.”
As more and more internet service providers allow their customers to access the internet via IPv6 by default, this will reduce latencies.
And most importantly, your domain has just gotten future-proof, and you didn’t even have to lift a finger for it, allowing you to take care of the things that matter the most: building your website!
Re: IPv4 addresses used up
Meanwhile, having one ipv6 packet on our telescope network causes all the antennas to crash.
- Pucksoppet
- Snowbonk
- Posts: 599
- Joined: Mon Nov 11, 2019 8:13 pm
- Location: Girdling the Earth
Re: IPv4 addresses used up
Ouch. A good example of a Ping of Death. Your network administrators must love this. IIRC, Windows PCs these days automatically run 'dual stack', so that implies someone plugging in a Windows PC unannounced will crash the antennas. Which is probably not good. To be fair, recent Linux distributions also implement dual stack, but I'd expect Linux users in general to have a bit more of a clue not to plug in devices where they are not wanted.
That said, I'm not covering myself in glory on the Linux front right now. I need to learn more about systemd and network startup, quickly.
Re: IPv4 addresses used up
I haven't enabled ipv6 on my Gentoo box. It also doesn't use systemd. Troglodyte, me?
Re: IPv4 addresses used up
I'm reading these posts but have barely a clue what they mean.
I'll just accept that the internet is magic and the folks who make it work are sorcerers.
I'll just accept that the internet is magic and the folks who make it work are sorcerers.
And remember that if you botch the exit, the carnival of reaction may be coming to a town near you.
Fintan O'Toole
Fintan O'Toole
- rockdoctor
- Clardic Fug
- Posts: 204
- Joined: Tue Nov 12, 2019 11:52 am
- Location: Paddington, London
Re: IPv4 addresses used up
If I want to be all modern, what is involved in switching from 4 to 6?
I have a largish home ethernetwork connected to Plusnet. Most things seem to be '6-compatible' these days, but I have the impression I still need to actively switch over...?
I have a largish home ethernetwork connected to Plusnet. Most things seem to be '6-compatible' these days, but I have the impression I still need to actively switch over...?
Re: IPv4 addresses used up
Plusnet (also my isp) don't do v6 so the ip address they give your router will be a v4 one (I checked). Providers that do v6 give you a range of globally unique ip addresses, enough for each device to have one, which is apparently the reason why it is a good thing. Probably you could do v6 locally but I am not sure there would be much point until your router can speak to the internet at large in v6 (assuming your router speaks v6). You're stuck with NAT which is apparently the bad thing with ipv4.rockdoctor wrote: ↑Fri Nov 29, 2019 8:38 pmIf I want to be all modern, what is involved in switching from 4 to 6?
I have a largish home ethernetwork connected to Plusnet. Most things seem to be '6-compatible' these days, but I have the impression I still need to actively switch over...?
- rockdoctor
- Clardic Fug
- Posts: 204
- Joined: Tue Nov 12, 2019 11:52 am
- Location: Paddington, London
Re: IPv4 addresses used up
I'm pretty sure most of my kit is modern enough to speak 6, so it's all down to Plusnet to modernise by the sound of it
- Little waster
- After Pie
- Posts: 2385
- Joined: Tue Nov 12, 2019 12:35 am
- Location: About 1 inch behind my eyes
Re: IPv4 addresses used up
I’m still wondering what happen to v5.
This place is not a place of honor, no highly esteemed deed is commemorated here, nothing valued is here.
What is here was dangerous and repulsive to us.
This place is best shunned and left uninhabited.
What is here was dangerous and repulsive to us.
This place is best shunned and left uninhabited.
Re: IPv4 addresses used up
It's more commonly called Internet Stream Protocol .